Aquaseal
Urethane Repair Adhesive & Sealant
The industry
standard for maximum strength repairs to wetsuits, dry
suits and all watersports products. Flexible urethane
formula waterproofs, seals and protects against abrasion.
Hundreds of watersports and household uses. For fast cure, use
with Cotol-240 Cure Accelerator.
Directions
for Neoprene Repair:
Clean damaged area with Cotol-240 Cure Accelerator/Precleaner
or solvent (paint thinner, nail polish remover or similar).
Trim loose threads. Non-fabric surfaces should be roughened
with sandpaper, then cleaned. Apply Aquaseal to surfaces
directly from tube or with knife or flat stick. Keep repair
level overnight. Avoid contact with other surfaces. Most
repairs reach full strength overnight (10-14 hours). Allow
longer for thickest repairs. For fastest cure (2 hours or
less), mix in Cotol-240.
Holes and Tears: Create backing with
removable tape. Fill void and 1/4" beyond edge with
Aquaseal. Remove tape after full cure.
Seams: Apply 1/16" thick bead
overlapping seams edges by at least 1/4". Apply with
slight pressure to saturate fabric surfaces.
High Wear Areas: Apply thin coat with knife
for flexible abrasion resistance.
Warning: Fully Cured Aquaseal is Slippery When Wet.
For added traction on footwear, sprinkle sand on uncured
Aquaseal 1/2 hour after applying.
Clean Up: To remove Aquaseal from hands, buff
with cloth soaked in paint thinner, nail polish remover or 99%
isopropyl alcohol.
Storage: Advance contents to tube neck. Wipe
clean and cap. Keep in cool, dry place; for extended life,
place in freezer. To thaw or for easier-flowing contents, soak
tube in warm water for 15 minutes. |
